Downlights, spotlights often appear around us, home, stores, museums, exhibition scenes, in the home lighting, architectural lighting is an important part, so maintenance and maintenance should also pay attention to, in order to understand how to understand how to correct maintenance methods, you can first read previous article to understand the structure and information of the relevant downlights.
Because the volume and volume of downlights and spotlights are small, the heat emitted by the light source is not easy to distribute, so we must pay attention to high temperature when replacing the light source to avoid being burned. It should be switched off for 10 minutes before replacing it.
First of all, you have to turn off the power switch to avoid the safety risks brought by live work!
Second, find a ladder or a strong chair to make sure it is stable when replaced.
Third, is to remove the downlight, you walk along the edge of the downlight hand can be buckled down, and then you will see the structure inside, one side of the spring buckle and then fixed the downlight and gypsum board ceiling, you only need to gently pull down, you can remove it, if it is a bright downlight, you need to rotate the light body to separate the light body and the base.
When replacing downlights and spotlights, Ensure that the lamp wire is properly connected to the power supply, hold down both sides of the lamp installation shrapnel when installing back, and press the middle to align the mounting hole, and then push into the ceiling, the position must be aligned, do not make mistakes. Ensure that the base and light body are fixed, and then release the handle to prevent the light body from falling down or injuring the operator if the installation is loose. After installation, turn on the power and observe for a few minutes to ensure that the lamp works normally and the replacement is completed.
The installation direction of downlights and spotlights is predominantly downward, resulting in minimal dust accumulation. However, it is crucial to exercise caution during the installation process to prevent contact with corrosive substances such as putty or paint on the surface of these fixtures. In case of accidental exposure, immediate removal using a clean towel followed by drying with a cotton cloth is recommended. When replacing the downlight source, it is advisable to avoid direct contact between sweaty hands and the reflective surface of the aluminum lamp cup since sweat possesses certain corrosive properties that can gradually diminish the reflection effect of said surface, thereby impacting the overall performance of the downlight.
Read more: Maintenance methods of downlights or spotlights